Advertisement
Quick Links
P127164-01
P/N 127164-01 Rev. C 06/2015
Parts included with this kit:
PART NO.
DESCRIPTION
126466-01
Blower Assembly L.
126466-02
Blower Assembly R.
126468-01
Speed Control Assembly
127164-01
Instruction Sheet
126972-01
Wiring Diagram
f i r e - p a r t s . c o m
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS This appliance is equipped with a three-prong
(grounding) plug for your protection against shock hazard and should be plugged directly into a properly
grounded three-prong receptacle.
(Check your appliance owner's manual for specific applications and
additional instructions.)
IMPORTANT: Read entire instruction sheet before installing blower kit.
This blower kit is approved for use with models listed above. Do not
use blower kit in any other fireplace models.
If any of these parts are missing or damaged, contact dealer where
you purchased this kit. If they cannot supply original replacement
parts, either contact your nearest Parts Central or contact IHP at
IHP.US.com for information.
Note: This installation requires the gas supply line to be disconnected
before removing log assembly. Call a qualified service person to
disconnect gas supply from fireplace.
WARNING: Turn off, unplug, and let fireplace cool
before installing blower kit. Only a qualified service
person should service and repair fireplace.
LOW PROFILE DUAL BLOWER KIT
QTY.
1
1
1
1
1
For more information, visit IHP.US.com
NOTICE: Log set/burner and hearth refractories, must be
removed before installing blower kit. Refer to owner's
manual for specific applications and additional instruc-
tions.
nect and disconnect fireplace with gas supply. Follow
all local codes.
installed in the right or left side of the bottom of
the fireplace base area, be sure that the electrical
power to the outlet is turned off before proceeding
with blower installation. Failure to do this may result
in serious injury.
The blower kit utilizes two rotary squirrel cage type blower with
magnetic attachment and variable speed control.
Note: This blower kit is approved for use with models listed on this
page. Do not use blower kit in any other fireplace models.
Save this manual for future reference
INSTALLATION INSTRUCTIONS
MODEL LPDBK (F1084)
ACCESSORY
For use with:
Astria™ Models:
DEVONSHIRE Series Direct Vent
Fireplace
WARNING: A qualified service person must con-
WARNING: If there is a duplex electrical outlet
Advertisement
Related Manuals for IHP LPDBK
Summary of Contents for IHP LPDBK
- Page 1 WARNING: A qualified service person must con- you purchased this kit. If they cannot supply original replacement nect and disconnect fireplace with gas supply. Follow parts, either contact your nearest Parts Central or contact IHP at all local codes. IHP.US.com for information.
- Page 2 WARNING: Reinstall any barrier removed before Spacers operating the fireplace. The barrier is designed to Firebox Bottom Screws reduce the risk of burns from hot glass. Do not operate the fireplace without the barrier installed. Figure 4 - Removing/Installing Burner Base IHP.US.com 127164-01C...
- Page 3 Note: The LPDBK blower kit, is for application into direct-vent models listed on the front page only and is already factory pre-wired. When installing the LPDBK blower kit, you must first check that all wiring connections are secure from the speed control to the blower. Make sure gasket material adhered to the bottom casing of blower is intact (See Figure 5).
- Page 4 Normally, all parts should be ordered through your IHP distributor 6. Peel off the backing paper and stick the supplied wiring diagram or dealer. Parts will be shipped at prevailing prices at time of order.