Safety Information; Maintenance - Keysight M9383B VXG-m Startup Manual

Step 1: Unpack, Inspect, and Verify Shipment
Safety Information
Both types, when used together, provide a significant level of ESD protection. Of the
two, only the table-mat and wrist-strap combination provides adequate ESD
protection when used alone. To ensure user safety, the static-safe accessories must
provide at least 1 MΩ of isolation from ground.
Safety Information

Maintenance

To remove dirt or dust from the external case of the M9383B VXG-m, clean the case
using a dry or slightly-dampened cloth only.
38
Conductive table-mat and wrist-strap combination
Conductive floor-mat and heel-strap combination
The safety of any system incorporating the equipment is the
responsibility of the assembler of the system.
Proper Ergonomics should be considered when using
accessories such as a keyboard or a mouse.
When installing the instrument(s) into a cabinet, consideration
shall be given to the convection flow into and out of the cabinet.
Consideration shall also be given to the individual instruments to
avoid having the heated discharge of one instrument, now
becoming the cooling intake air for another instrument. Another
area of concern is verification that the maximum ambient
operating temperature of the instrument(s) is not exceeded by
cabinet installation. Keysight recommends forced air convection
whenever an instrument(s) are installed in a cabinet and further
recommends that the maximum operating temperature of the
cabinet be reduced 10°C from the lowest, of the maximum
operating temperature of a single instrument. If there are any
concerns or special requirements a Keysight Field Engineer
should be consulted to assure instrument(s) temperature
compliance and performance.
To prevent electrical shock, disconnect the AC/DC adapter from
the mains before cleaning. Use a dry cloth or one slightly
dampened with water to clean the external case parts. Do not
attempt to clean internally.
M9383B Startup Guide