Bintroduction And Disclaimers; Cprepare The Door For The Appropriate Exit Device - Kaba E-730 Series Installation Manual

Exit device operators
Table of Contents

Advertisement

B
INTRODUCTION AND DISCLAIMERS
Please read and follow all directions
!
carefully.
Target Audience
Please read and follow all directions carefully. These
instructions are designed for use by maintenance
professionals or lock installers who are familiar with
common safety practices and competent to perform
the steps described. Kaba Ilco is not responsible for
damage or malfunction due to incorrect installation,
that may arise.
C
PREPARE THE DOOR FOR THE APPROPRIATE EXIT DEVICE
1) Choose from the center of this booklet the drilling
template of the lock for the exit device to be assem-
bled on the door.
2) Mark the desired handle height on the edge of the
door. (see Fig.1)
3) Mark the backset vertical line on each side of the
door. Consult the exit device manufacturer's instruc-
tions for the correct backset. The backset shown
on the paper template is for reference only. use exit
device backset.
Respect all applicable building codes
!
regarding the handle height of the lock
and positioning of the bar.
4) Position the drilling template (attached in this book-
let) on the inside of the door aligning the door handle
height mark and backset vertical line mark with the
lines on the template. Mark the door for the holes posi-
tion.
5) Drill holes to diameters specified on the drilling tem-
plates.
Drill the holes in the door required for the exit
device according to the manufacturer's instruc-
tions .
Drill from both sides of the door to prevent
!
unsightly damage. Refer to template for
drill size and depths
4
Warnings and Conditions
Important: Carefully inspect windows, doorframe,
door, etc. to ensure that the recommended
!
procedures will not cause damage. Kaba standard
warranty does not cover damages caused by
installation.
Caution: Wear safety glasses when making the holes.
!
Fig. 1
3 through holes
3
4
From the inside, counter bore
5/16 dia. X 3/4 Deep
See Drilling Template
Fig. 2
2 or 4 Holes
Inside of Door
E-730/630/750/79E/ RT Series Installation Guide - PK3677_T_04_16
Backset Vertical Line

Advertisement

Table of Contents
loading

This manual is also suitable for:

750 series79e seriesRt series630 series

Table of Contents