Table of Contents
Advertisement
Leuze
electronic
8.5
Configuration (Parameterization)
The BCL is adapted to the reading conditions on site through configuration. Reading, evaluation and
output characteristics can be parameterized as needed. The starting point for this is the factory default
setting or a BCL parameter set which is already generated and defined according to application.
The BCL offers two configuration procedures:
• Configuration with the PC software BCL-Config
(Setting parameter values via the serial interface)
• Configuration with command strings
(Setting parameter values via the serial interface)
In the parameterization mode, the BCL does not output any read results.
8.5.1 Configure the BCL with User Interface of BCL-Config
When using the software BCL-Config, a PC has to be connected and the software installed in the PC.
The connection of the PC to the BCL is described in Section 7.5.5, on page 90.
Transfer the Parameter Set between BCL-Setup and the BCL
BCL-Config operates in off-line mode during the parameterization of the BCL. In order to be able to
modify the current parameter set of the BCL, the parameter set has to be loaded from the BCL into
BCL-Config first. This process is called uploading. BCL-Config always uploads a copy of the current
parameter set from the BCL. The current parameter set remains unchanged until it is overwritten by
BCL-Config.
Changes made to the current parameter set in BCL-Config does not become effective until after being
transferred to the BCL. BCL-Config always loads a copy of the complete parameter set down to the
BCL, i.e. all parameter values up to now are overwritten in the BCL. The transfer and storage of the
parameter values into the BCL is called downloading.
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Technical Description BCL 90
Operation
103
Advertisement
Table of Contents
