Oil Level & Oil Change - Benelli TnT300 Owner's Manual

MAINTENANCE SCHEDULE
* Indicates items that should only be repaired by authorized dealers: with qualified tools and inspection materials provided by the
manufacturer; by persons with a mechanical repair certification; required to be maintained according to the manual. Examination
and repair are suggested to be done by an authorized dealer for the sake of safety, in these cases.
NOTE:
1. Inspect more frequently if riding in dusty areas.
2. Repeat the maintenance schedule again once the vehicle exceeds the end of the schedule.
3. Service the vehicle more frequently if used in heavy conditions such as rough roads.
OIL LEVEL & OIL CHANGE
Check the oil level before starting the engine.
Put the motorcycle on the side stand.
Hold the vehicle vertically. Inspect the engine oil level through the
engine oil level window on the right side on the engine.
Check if the oil level is between the maximum and minimum level.
If not, fill with qualified engine oil to the proper level.
Oil Change & Oil Filter Replacement
1. Remove the oil filter using the special tool and the oil drain bolt
to start the oil draining.
2. Replace the oil filter with a new one if needed.
3. Install the oil filter with the special tool and the oil drain bolt.
4. Fill the engine with qualified engine oil.
5. Start the engine and allow it to idle for several minutes then
turn it off.
6. Make sure the oil level reaches the upper limit mark without any oil leakage.
TnT300