INSTALLATION INSTRUCTIONS
BACK
SUPPORT
HOT SUPPLY
Warning: Failure to follow these instructions, or improper operation, may
damage the valve and void the warranty.
- Make sure the water supplies are off.
- Remove all the trim items (plate, handle, and flange) before installation.
- Determine where the finished wall will be. This measurement is necessary to accurately plumb in the valve.
- Install valve into the wall making sure the MIN/MAX sticker in the mud guard is flushed with the finished wall (See Diagram A)
- Secure the valve firmly against the studs, align the valve horizontally, vertically, and parallel to the wall.
- Make sure to flush or raise grouting on the tiled wall surface.
Note: It is critical to completely flush the lines of all dirt and debris prior to installing the valve to the supply lines.
Note: Do not solder the connections between the pipes and valve body, as you may damage the non-metalic parts in the valve.
- Connect the HOT water supply to the left inlet of the valve and COLD supply to the right inlet of the valve.
- Connect the outlet pipe to shower connections and to any optional devices.
- Test for proper function before closing walls. Do this by pressurizing both HOT and COLD lines.
OUTLETS
(LEFT) (TOP)
(RIGHT)
MOUNT SCREWS
(not provided)
DIAGRAM (A)
COLD SUPPLY
0 5