INSTALLATION INSTRUCTIONS
DESCRIPTION
This product is precision engineered to provide satisfactory performance provided it is installed and operated in
accordance with our recommendations contained in this manual. In order to fully enjoy the comfort, safety and the
reliability of your pressure balancing valve, be certain to familiarize yourself with the contents of this manual.
33"
FLOOR
LINE
INSTALLATION
NOTE: Failure to follow these instructions may cause damage or improper operation to the unit and nullify the warranty.
ROUGH IN
- Make sure the water supply is off.
- Secure the valve firmly against the stud. Make sure the 1/2" shower outlet is in the up position.
- Make sure to flush or raise grouting on the tiled wall surface.
- Adjust the All Thread depth against the Teflon Washer and Limit Stop.
Screw the All Thread against the Teflon washer until it is pressured gently against each other.
- Tighten firmly the Lock Nut against the Lock Plate.
- Position the valve using the dimension shown in the illustration B.
3.00"
WALL LINE
1/2"
78"
1/2"
All Thread
Broach
Extension
Lock Nut
Lock Plate
Diverter Rod
SPECIFICATIONS AND DIMENSIONS
Minimum operating pressure
Maximum operating pressure 145 psi
Maximum test pressure
Hot and cold water inlets
Shower outlet
Flow capacity 5 USGPM@ 50 psi
Finished wall adjustment : see Illustration B
Trim Plate
FLANGE WASHER HANDLE FLANGE HANDLE BELL
Diverter Knob
Diverter Rod O-Ring
20 psi
500 psi
1/2" IPS
1/2" IPS
HANDLE
ILLUSTRATION B
0 2