Advertisement
INSTALLATION INSTRUCTIONS
DESCRIPTION
This product is precision engineered to provide satisfactory performance provided it is installed and operated in
accordance with our recommendations contained in this manual. In order to fully enjoy the comfort, safety and the
reliability of your pressure balanced valve, be certain to familiarize yourself with the contents of this manual.
WALL LINE
46"
FLOOR
LINE
INSTALLATION
NOTE: Failure to follow these instructions may cause damage or improper operations and nullify the warranty.
ROUGH IN
- Make sure the water supplies are off.
- Remove all the trim items (plate, handle and flange) before installation.
- Secure the valve firmly against the stud. Make sure the Ω" shower outlet is in the up position.
- Make sure to flush or raise grouting on the tiled wall surface.
- Adjust the All Thread depth against the Teflon Washer and Limit Stop.
Screw the All Thread against the Teflon washer until it is pressured gently against each other.
- Tighten firmly the Lock Nut against the Lock Plate.
- Position the valve using the dimension shown in the illustration A.
3.25Ó
center of inlet
78"
(1981 mm)
Trim Plate
All Thread
Stem
Lock Nut
Lock Plate
finished wall
SPECIFICATIONS AND DIMENSIONS
Minimum operating pressure
Maximum operating pressure 145 psi
Maximum test pressure
Hot and cold water inlets
Shower outlet
Flow capacity 5 USGPM@ 50 psi
FLANGE WASHER
HANDLE FLANGE
FLANGE ADAPTER
ILLUSTRATION A
DT2/DT3-KL, KR, KT_ _
20 psi
500 psi
Ω" IPS
Ω" IPS
HANDLE BELL
HANDLE
0 2
Advertisement
