Centrica Panoramic Power Installation And Configuration Manual page 25

Bridge Installation and configuration guide
If you are using Wi-Fi:
Verify the wireless network reception strength in the status page. The level
should be at least two, preferably three (out of five).
If no reception level is showing and "Connecting..." is shown instead, it means
that the bridge cannot establish Wi-Fi network connectivity. In this case, please
verify your Wi-Fi credentials (SSID, Security Type or password).
If the LED blinks green but does not turn solid, it means that local network
connectivity is established but the bridge cannot access the PowerRadar server.
This is often caused by local firewalls blocking TCP port 8051. You can verify this
using the Diagnostics tool or with your system administrator.
If you are using cellular:
Verify the cellular network reception strength in the status page. The level
should be at least three (out of five).
If no reception level is showing and "Connecting..." is shown instead, it means
that the bridge cannot establish cellular network connectivity. In this case,
please verify your cellular credentials (APN, PPP credentials where needed), and
make sure the SIM card has a valid and enabled data plan.
You can test the cloud connectivity using the
Problem
The bridge does not connect to the cellular network when using the SIM card (
LED is off).
Solutions
Make sure the SIM card is in place before connecting the bridge to the power
source.
After verifying that the SIM card is tightly secured in its slot, disconnect the
bridge from the power source and reconnect it.
Verify with your service provider that a data plan is enabled for your SIM card.
The bridge connects to the cellular data network only if the SIM card has a data
plan.
In low reception areas it may take a while for the bridge to connect. Enter
configuration mode and check the reception bar in the Status page.
Problem
The bridge does not return to normal operation after a firmware upgrade (
LED lights red).
Diagnostics tool.