Centrica Panoramic Power Installation And Configuration Manual page 14

Bridge Installation and configuration guide
How to Proceed
1. In Connection Type, select
2. Use the View cellular networks
relevant cellular network (this can take up to 30 seconds). Then
enter the APN you received from the cellular network operator. If
required, enter PPP details.
3. To save the configuration to the bridge, click
Important If you leave this page before saving your settings, they will not be
saved.
4. To discard changes made to an unsaved configuration and return to
the saved settings, select
5. To use the settings displayed on the screen to configure another
bridge, select Save Configuration to
This allows you to create different settings and save them to a file, without
updating the bridge configuration.
For more information, see
Configuration File.
6. To exit configuration mode, disconnect the bridge from the power
source.
7. Install the bridge as explained in
8. When using the Internal GSM
slot with the truncated end, as shown below.
Connect via Cellular.
button to verify reception of the
Load Configuration from
File.
Loading the Bridge Configuration from a
Mounting the
Modem, insert the SIM card into the
Save Settings.
Bridge.
Bridge.