Upgrading The Firmware Version - Centrica Panoramic Power Installation And Configuration Manual

Bridge Installation and configuration guide
4. Click Ping to google.com
working.
If there is no connection, check the bridge configuration
parameters and network settings.

Upgrading the Firmware Version

This section explains how to upgrade the bridge to the latest firmware version.
Prerequisites
Make sure you have the following items:
USB flash drive with the upgraded firmware, or a FAT-32 formatted USB flash
drive if you need to download the firmware from your email account.
How to Proceed
1. Download the firmware to the root directory of the USB flash drive,
if necessary.
2. Make sure the firmware file is the only .bin file in the root directory
of the USB flash drive.
3. Connect the USB flash drive to the USB port on the bridge.
4. Boot and wait for the LED self-test sequence to end. Note that this is
relevant only if the bridge is not yet operational.
Note If you proceed to Step 5 before the self-test sequence ends, the bridge
enters configuration mode rather than upgrade mode.
5. If the bridge is connected to the LAN network,
the LAN network.
6. Press the Configuration
to make sure the Internet connection is
disconnect it from
button for approximately 30 seconds.