Panasonic CM202 Series Maintenance Manual page 95

3.
Removing the vacuum filter
Pin
444C-457E
4.
Cleaning
a. Cleaning the nozzle holder and the nozzle-holder shaft
444C-423P
444C-424P
444C-425P
To the next page
444C-E-MMA01-A05-04
Filter
Pulling jig
Check Every 140 Hours (Once a Week)
1.
Insert the pulling jig from the oppo-
site side, and remove the dirty filter.
(Push it firmly.)
1.
Clean the inside of the nozzle holder
with the air ejector and wipe the in-
side of the nozzle holder with the
swab.
444C-507P
2.
Clean the nozzle holder taper face,
nozzle clamp arm, and spring for
clamp arm holder with a cotton bud
which is soaked with absolute alco-
hol.
3.
Blow away dirt on the nozzle holder
taper face, nozzle clamp arm, and
spring for clamp arm holder with the
air ejector.
1
Page 1-33