Cleaning And Lubricating The Tape Feeder Table - Panasonic CM202 Series Maintenance Manual

1-4-2

Cleaning and Lubricating the Tape Feeder Table

Tools Cloth
Clean and lubricate the tape feeder table.
∗ For DU/DHU specifications, it is necessary to remove the feeder base cover for the maintenance.
"1-2-3 Setting and Removing the Feeder Base Cover (Only for DU/DHU
OFF (
444C-509P
444C-409P
444C-509P
To the next page
444C-E-MMA01-A04-04
SERVO
) ON ( )
Tape feeder table
Rail groove
Check Every 140 Hours (Once a Week)
Required time
1.
Turn OFF the servo switch.
2.
Open the safety cover.
3.
Clean the surroundings of the tape
feeder tables with the vacuum cleaner
or cleaning brush.
∗ If chip components have dropped on the tape
feeder tables, the tape feeder ski will be
damaged and the pick-up position may be
dislocated. And, what's worse, pick-up errors
can be increased. Before changing production
models or the tape feeder parts, be sure to
clean there.
4.
Ensure that there is no damage to the
tip of the projection rod.
Projection rod
5.
Apply grease to the linear-bearing rail
grooves for the double tape feeder.
∗ Only when the optional double tape feeder is
installed, carry out this operation.
Linear bearing
1
5 minutes
Specifications)"
Page 1-25