Operation - Worx WG150E Manual

3. HOW TO CHARGE YOUR BATTERY
PACK
Connect the battery charger to the power
supply and the green light (20) will illuminate
Then, fully insert the battery pack into the
charger to make the connections and the red
light (21) will illuminate to show charging
has started A discharged battery at normal
ambient temperature will take approximately
1 hours to reach full charge. When charging is
completed the green light (20) will illuminate to
indicate end of charge
Due to the different conditions, the charging
time would be longer.
Note: Green = Power on,
Red = Charging,
Battery pack inserted +green = Charging
completed
The battery pack can then be removed for use
in your tool. The charger timer circuit and bat-
tery pack temperature safety cut-out device
prevent overcharge of your battery pack.
WARNING: After long usage the battery
will become hot, let the hot battery cool
down for 1 hour before recharging.
4. TO REMOVE OR INSTALL BATTERY
PACK
Locate latches on side of battery pack and
depress both sides to release battery pack from
your grass trimmer. Remove battery pack from
your grass trimmer (See E). After recharge
insert the battery pack into grass trimmer's
battery port. A simple push and slight pressure
will be sufficient.
5. SAFETY ON/OFF SWITCH
Your switch is locked off to prevent accidental
starting. Depress lock off button (B) then on/off
switch (A) and release lock off button (B). Your
switch is now on. To switch off just release the
on/off switch (See Fig F)
WARNING: The cutting head continues
to rotate after the trimmer has been
switched off, wait until it has stopped then lay
down the tool.
6. ADJUSTMENT OF THE TELESCOPIC
SHAFT (SEE G)
Unscrew the lower locking knob (4) in the direc-
Cordless Grass Trimmer
CRA-WG150E-M-061102.indd 11
(See D).
tion indicated to unlock.
Adjust the length of the telescopic shaft to the
most comfortable length.
Tighten the lower locking knob.
7. MAIN HANDLE ROTATION (SEE H)
Unscrew the upper locking knob (3) in the
direction indicated to unlock.
Adjust the angle of the main handle to be
clockwise 90 degree max.
Turn the upper locking knob in the opposite
direction to lock.
8. ADJUSTMENT OF AUXILIARY HANDLE
Pull up the auxiliary handle locking lever (5).
Hold the lever and rotate the auxiliary handle
to the most comfortable and balanced position
(See I)
Release the lever, your auxiliary handle has
been locked.
9. ADJUSTMENT OF THE TRIMMER HEAD
ANGLE TO THE SHAFT
Use both of your hands, one grips the shaft,
another on the head, then apply adequate
force to adjust the trimmer head to the most
comfortable position. The ratchet mechanism
will make a heavy clicking sound which is
normal and not a defect (See Fig J).

OPERATION

WARNING: Always wear the eye
protection. Never lean over the
trimmer head. Rocks or debris can
ricochet or be thrown into eyes and face
and cause blindness or other serious
injury when opening unit, check for the
following:
Wear eye protection and heavy clothing. Hold
front handle with one hand and auxiliary handle
with another hand. Keep unit below waist level.
Work only from your right to your left to ensure
debris is thrown away from you. Without
bending over, keep line near and parallel to the
ground (perpendicular when edging) and not
crowded into material being cut.
WARNING: Make sure that line is
fed out before operation. Make
11 11
ENG
2007-3-28 17:11:05