X1, Module Bus - Bosch Rexroth IndraDrive C HCS03.1 Planning Manual

Rexroth IndraDrive C HCS03.1

X1, Module Bus

Graphic Representation
DOK-INDRV*-HCS03.1****-PR02-EN-P
CAUTION
CAUTION
CAUTION
The module bus is used to exchange data between two converters of
identical rating or between one converter and inverters connected to the
DC bus.
Fig. 6-20: Graphic representation module bus
Design
Type
Ribbon cable connector
Ribbon cable socket
Fig. 6-21: Design module bus
Note: When extension cables are used for the module bus, they
must be shielded. Their total length must not exceed 40 m.
Damage caused by voltage arcing!
⇒ When electrical lines and not the contact bars are
used to connect the converter, the connections must
be executed correctly.
Damage caused by voltage arcing!
⇒ If drive controllers are stacked in the control cabinet,
the connections for the DC buses between the drive
controllers have to be correctly made.
Damage due to converter overload!
⇒ Only converters of identical DC bus power may be
connected.
X1 out X1 in
No. of poles
8
8
6-17
Electrical Data
X1f2.FH7
Type of design
Connector at device
Socket at ribbon cable