3.12 Protection Against Pressurized Systems - Bosch Rexroth IndraDrive C HCS03.1 Planning Manual

Rexroth IndraDrive C HCS03.1

3.12 Protection Against Pressurized Systems

DOK-INDRV*-HCS03.1****-PR02-EN-P
Safety Instructions for Electric Drives and Controls
Certain motors and drive controllers, corresponding to the information in
the respective Project Planning Manual, must be provided with
pressurized media, such as compressed air, hydraulic oil, cooling fluid
and cooling lubricant supplied by external systems. Incorrect handling of
the supply and connections of pressurized systems can lead to injuries or
accidents. In these cases, improper handling of external supply systems,
supply lines or connections can cause injuries or material damage.
Danger of injury by incorrect handling of
pressurized systems!
⇒ Do not attempt to disassemble, to open or to cut a
pressurized system (danger of explosion).
CAUTION
⇒ Observe the operation instructions of the respective
manufacturer.
⇒ Before disassembling pressurized systems, release
pressure and drain off the fluid or gas.
⇒ Use suitable protective clothing (for example safety
glasses, safety shoes and safety gloves)
⇒ Remove any fluid that has leaked out onto the floor
immediately.
Note: Environmental protection and disposal! The media used in the
operation of the pressurized system equipment may not be
environmentally compatible. Media that are damaging the
environment must be disposed separately from normal waste.
Observe the legal requirements in the country of installation.
3-11