Table of Contents
Advertisement
Rexroth IndraDrive C HCS03.1
Replacing Cables
DOK-INDRV*-HCS03.1****-PR02-EN-P
Lethal electric shock caused by live parts with
more than 50 V!
⇒ Power connectors of the cables may only be
separated or connected if the installation has been
ATTENTION
de-energized!
Note:
When replacing cables, observe the instructions of the
machine manufacturer.
If you do not use ready-made Rexroth cables, check to ensure
that the cables match the terminal diagram of the machine
manufacturer!
• open main switch
• make sure main switch cannot be switched on again
• disconnect plug-in connectors
Note:
When replacing cables, cover the open mating sites of power
lines
with
liquid/lubricant or soiling may occur (allowed degree of soiling
according to EN50178: 2).
• replace cable
Property damage caused by bad power
connectors!
⇒ Only connect clean and dry power connectors.
ATTENTION
• connect plug-in connectors
protective
caps
if
sprinkling
8-3
Replacing Devices
with
cooling
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Rexroth IndraDrive C HCS03.1 and is the answer not in the manual?