Removing An Expansion Module - H3C S6850 Series Installation Manual

Figure 59 Installing the LSWM18CQ interface module

Removing an expansion module

CAUTION:
• Before you remove an expansion module, remove the cable from it to avoid cable damage.
• If you are not to install a new expansion module after removing the original one, install a filler
panel in the slot to prevent dust and ensure good ventilation.
To remove an expansion module:
Prepare an anti-static bag.
1.
Wear an ESD wrist strap and make sure the wrist strap makes good skin contact and is reliably
2.
grounded.
Press the latch to release the ejector lever as shown by callout 1 in
3.
Rotate outward the ejector lever as shown by callout 2 in
4.
Pull out the expansion module slowly out of the expansion slot, as shown by callout 3 in
5.
60.
Place the removed expansion module in the anti-static bag.
6.
Figure 60 Removing an LSWM18CQ interface module
2
1
3
Figure
36
Figure 60.
60.
Figure