Connecting A Dc Power Cord; Installing/Removing Expansion Modules - H3C S6850 Series Installation Manual

Figure 55 Connecting an AC power cord to the LSVM1AC650 power module
(1) Cable tie
(2) Tighten the cable tie to secure the power cord to the handle of the power module

Connecting a DC power cord

Align the power cord plug with the power receptacle on the power module, and insert the plug
1.
into the receptacle (see
The plug and receptacle are foolproof. If you cannot insert the plug into the receptacle, re-orient
the plug rather than use excessive force to push it in.
Use a cable tie to secure the power cord to the handle of the power module, as shown in
2.
55.
Connect the other end of the power cord to the DC power source.
3.
Figure 56 Connecting a DC power cord to the LSVM1DC650 power module

Installing/removing expansion modules

CAUTION:
When you install or remove an expansion module, follow these guidelines:
• Never touch the components on the expansion module surface with bare hands.
• Do not use excessive force.
The S6850-2C switch provides two expansion slots. For the available expansion modules, see
"Appendix B
Figure
FRUs."
56).
34
Figure