Sfp+ Port; Leds; System Status Led; Qsfp28 Port Led - H3C S6850 Series Installation Manual

SFP+ port

The LSWM124XG2Q, LSWM124XG2QFC, and LSWM124XG2QL interface modules each provide
24 SFP+ ports. The SFP+ ports support the following transceiver modules and cables:
•
10-GE SFP+ transceiver modules in
•
10-GE SFP+ copper cables in
•
10-GE SFP+ fiber cables in
•
GE SFP transceiver modules in
NOTE:
When a GE SFP module is installed in an SFP+ port on the LSWM124XG2QL interface card, the
SFP+ port does not support rate and duplex autonegotiation. You must configure the speed 1000
and duplex full commands on both ends.

LEDs

System status LED

The system status LED shows the operating status of the switch.
Table 33 System status LED description
LED mark
SYS

QSFP28 port LED

Table 34 QSFP28 port LED description
LED status
Steady green
Flashing green
Steady yellow
Flashing yellow (3 Hz)
Off
Table
Table
Status Description
Steady green The switch is operating correctly.
Flashing green The switch is performing power-on self test (POST).
Steady red The system has failed to pass POST or has problems such as fan failure.
Helps you to locate the switch.
Flashing blue
To locate the switch in the rack, execute the locator blink blink-time
(3 Hz)
command. The LED then flashes blue at 3 Hz.
Off The switch is powered off or has failed to start up.
Description
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 100 Gbps.
The port is sending or receiving data at 100 Gbps.
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 10 Gbps, 25 Gbps, or 40 Gbps.
The port is sending or receiving data at 10 Gbps, 25 Gbps, or 40 Gbps.
No transceiver module or cable has been installed or no link is present on the port.
Table 30.
31.
32.
Table 17.
71