Hydraulic Pump - Upright X26N Service & Parts Manual

Hydraulics
H
Y D R A U L I C
The Hydraulic Pump is located in the Power Module, and is mounted on the rear of the motor.
R
EMOVAL
NOTE: If the hydraulic tank has not been drained, suitable means for plugging the hoses should be provided to prevent
excessive fluid loss.
1. Mark, disconnect and plug the hose assemblies.
2. Loosen the capscrews and remove the pump assembly from the motor.
I
NSTALLATION
1. Lubricate the pump shaft with general
purpose grease and attach the pump
to the motor with the capscrews.
2. Using a crisscross pattern, torque
each capscrew a little at a time until
all capscrews are torqued to 27N-m
(20 ft-lbs).
3. Unplug and reconnect the hydraulic
hoses.
4. Check the oil level in the hydraulic
tank before operating the work
platform.
Page 3-10
P
U M P
Figure 3-10: Hydraulic Pump Assembly
1. Inlet Hose 4. Pump Assembly
2. Outlet Hose 5. Electric Motor
3. Capscrew
Section 3 - Service & Repair
508244-002