Table of Contents
Advertisement
Installation and start-up should be performed by a qualified installer who thoroughly read, understands and
follows these instructions.
If you have questions concerning the installation, operation, maintenance or service of this product, write
Technical Service Department APW/Wyott Foodservice Equipment Company, P.O. Box 1829, Cheyenne,
WY 82003.
Before installing and operating this equipment be sure everyone involved in its operation is fully trained and
is aware of all precautions. Accidents and problems can result by a failure to follow fundamental rules and
precautions.
The following words and symbols, found in this manual, alert you to hazards to the operator, service
personnel or the equipment. The words are defined as follows.
DANGER: This symbol warns of imminent hazard which will result in serious injury or
!
death.
WARNING: This symbol refers to a potential hazard or unsafe practice, which could result
!
in serious injury or death.
CAUTION: This symbol refers to a potential hazard or unsafe practice, which may result in
!
minor or moderate injury or product or property damage.
NOTICE: This symbol refers to information that needs special attention or must be fully
!
understood even though not dangerous.
THIS MANUAL SHOULD BE RETAINED FOR FUTURE REFERENCE
CAUTION: These models are designed, built, and sold for commercial use. If these
models are positioned so the general public can use the equipment, make sure that
!
cautions, warnings, and operating instructions are clearly posted near each unit so that
anyone using the equipment will use it correctly and not injure themselves or harm the
equipment.
WARNING: Check the data plate on this unit before installation. Connect the unit only to
!
the voltage and frequency listed on the data plate. Connect only to 1 or 3 phase as listed on
the data plate.
WARNING: Improper installation, operation, service or maintenance can cause property
!
damage, injury or death. Read and understand these instructions thoroughly before
positioning, installing, maintaining or servicing this equipment.
WARNING: Electrical and grounding connections must comply with the applicable
!
portions of the national electrical code and/or other local electrical codes.
WARNING: Disconnect device from electrical power supply and place a Tag Out-Lockout
!
on the power plug indicating that you are working on the circuit.
SAFETY PRECAUTIONS
GENERAL INFORMATION
3
!
!
!
!
!
!
!
!
!
Advertisement
Table of Contents
