1. Turn power off to the treater and treater components.
2. Remove shields from the seed wheel and remove any debris or build-up.
Compressed air can be used to blow out any foreign material.
3. Turn power back on to the treater and run seed wheel to help remove any
additional debris. Compressed air can be used to blow out any foreign material.
4. Check brushes for wear (below).
5. Wipe off and clean the lens of the proximity switches (below).
6. Disconnect power and mount all guard back in place.
7. Tarp or cover the supply hopper and seed wheel to keep out any dirt or unwanted
pests
.
LPV SEED TREATER
SEED WHEEL & SUPPLY HOPPER
Proximity Switch
Motor
Brush
Page 43