Recommended Slot Locations For Interface Modules - Fortinet FortiGate-7000E Series System Manual

Hide thumbs Also See for FortiGate-7000E Series:
Table of Contents

Advertisement

FortiGate-7040E hardware assembly and rack mounting
To insert FIM and FPM modules, see the guide supplied with the module.
FIM-7920E front panel
Status, Alarm
HA, and Power
LEDS
Power
Power
Slider
Button
FIM-7920E
USB
NMI
Secure
Button
Screw
Module
Lever

Recommended slot locations for interface modules

If you are installing different FIM modules in the FortiGate-7040E chassis, for optimal configuration you should install
the module with the lower model number in slot 1 and the module with the higher number in slot 2.
FortiGate-7040E System Guide
Do not operate the FortiGate-7040E chassis with open slots on the front or back panel. For
optimum cooling performance and safety, each chassis slot must contain an FIM or FPM or
an FIM or FPM blank panel (also called a dummy card). For the same reason, all cooling fan
trays, power supplies or power supply slot covers must be installed while the chassis is
operating.
MGMT1 - MGMT4
10/100/1000BASE-T Copper
Management Interface
M1 and M2 10GigE Base
Channel SFP+ Interfaces
(heartbeat and management)
You must carefully slide the module all the way into the chassis slot, close the module levers
to seat the module into the slot, and tighten the secure screws to make sure the module is
fully engaged with the backplane and secured. You must also make sure that the power
sliders are fully closed by gently pushing them down.
Installation Highlights :
1. Module levers must be closed.
2. Secure screws must be tightened.
3. Power sliders must be fully closed for the module to get power and start up.
If the module is not receiving power all LEDs remain off.
All FIM and FPM-7000 series modules must be protected from static discharge and physical
shock. Only handle or work with these boards at a static-free workstation. Always wear a
grounded electrostatic discharge (ESD) preventive wrist strap when handling these boards.
C1 to C4
100GigE Fabric Channel
QSFP28 Network
Interfaces (data)
23
Power
Slider
Module
Secure
Lever
Screw
Fortinet Technologies Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fortigate-7040e

Table of Contents