Lexus LX 570 Owner's Manual page 138

Changing the door unlock function setting
■
It is possible to set which doors the entry function unlocks using the wireless remote con-
trol.
Turn the engine switch off.
1
Cancel the intrusion sensor and tilt sensor of the alarm system to prevent unintended
2
triggering of the alarm during the setting change. (P. 90)
When the indicator light on the key surface is not on, press and hold
3
approximately 5 seconds while pressing and holding
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds, and
repeat step
Multi-information
display
(Left-hand drive
vehicles)
(Right-hand drive
vehicles)
To prevent unintended triggering of the alarm, unlock the doors using the wireless
remote control and open and close a door once after the settings have been changed. (If
a door is not opened within 30 seconds after
again and the alarm will automatically be set.)
In a case that the alarm is triggered, immediately stop the alarm. (P. 87)
LX570_450d_OM_OM60R63E_(GE)
3-2. Opening, closing and locking the doors
.)
3
Unlocking function
Holding the driver's door handle
unlocks only the driver's door.
Holding a passenger's door han-
dle unlocks all the doors.
Holding a door handle unlocks
all the doors.
.
Beep
Exterior: Beeps 3 times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
is pressed, the doors will be locked
137
for
3