Troubleshooting - Philips HR1757/81 User Manual

Troubleshooting

Problem
The appliance does not work.
The blade unit or motor unit is
blocked.
The motor unit gives off an
unpleasant smell the first few times
the appliance is used.
The appliance makes a lot of noise,
smells, feels hot to the touch, emits
smoke, etc.
The mill vibrates strongly, produces a
lot of noise or the blade unit is out of
alignment.
Powder leaks from the mill
Although the filter has been
assembled, the fruit juice or soy milk
contains pulp.
* If problems persist or if other problems occur, please contact the Philips Customer Care Centre or the nearest
Philips service centre.
Cheese cake
- 4 eggs
- 525 ml milk
- 75 g margarine
- 90 g Parmesan cheese cut into 1-cm cubes
- 440 g sugar
- 290 g cornflour
- 250 g wheatflour
- 1 tbsp baking powder
Put the eggs, milk, margarine, Parmesan cheese and sugar in the jar. Let
B
the appliance run at maximum speed for 10 seconds.
Add the cornflour spoon by spoon and let the appliance run for 20
B
seconds at maximum speed.Then add the wheatflour spoon by spoon
and let the appliance run for another 30 seconds at maximum speed.
Add the baking powder and let the appliance run for 10 more seconds.
Then turn the appliance off. Put the mixture in a baking tin that has
been greased with oil or margarine and then floured. Bake the cheese
cake in the oven at 200 - 210cC for approximately 35-40 minutes.
Solution
The appliance is provided with a safety system.The appliance will not work if
the accessories have not been assembled properly on the motor unit or have
not been assembled at all. Check whether the accessories have been
assembled properly (see various sections of these direction for use). Switch off
the appliance first!
Switch off the appliance and process a smaller quantity.
This is normal. If the appliance continues to give off this smell after you have
used it a few times, check whether the quantity you are processing, the
processing time or the processing speed are correct.
Switch off the appliance and unplug it. Contact the nearest Philips service
centre or take the appliance to your dealer.
Check whether the blade unit has been properly assembled onto the beaker.
Check whether the rubber ring has been properly assembled.
Make sure the rubber ring has been assembled properly.The ring should lie flat
round the interface. Note: a small amount of leakage is normal.
Make sure that the filter has been assembled properly in the blender jar.
ENGLISH
13