Replacing A Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha AL125FC 2012 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
ZAUU0951
1. Turn signal light bulb socket (× 2)
4. Remove the burnt-out bulb by
pulling it out.
5. Insert a new bulb into the socket
by pushing it in until it stops.
NOTICE
7
_
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
_
6. Install the socket (together with
the bulb) by turning it clockwise.
7. Install the panel and cowling.
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
If a tail/brake light bulb or a rear turn
signal light bulb burns out, replace it as
follows.
Tail/brake light bulb
1. Open the seat. (See page 4-9.)
2. Remove the panel by removing
the screws, and then pulling the
panel outward.
ECAU0080
1
ZAUU0654
1. Screw (× 2)
3. Remove the bulb socket (together
EAUU0881
ZAUU0656
1. Tail/brake light bulb socket
4. Remove the burnt-out bulb by
ZAUU0657
1. Tail/brake light bulb
7-31
with the bulb) by turning it coun-
terclockwise and pulling the tail-
light bulb socket up at an angle.
pushing it in and turning it coun-
terclockwise.
1
1