Yamaha AL125FC 2012 Owner's Manual page 49

ZAUU0056
1. Engine oil strainer
2. Compression spring
3. O-ring
TIP
_
When only changing the engine oil, re-
move drain bolt A. When changing the
engine oil and cleaning the engine oil
strainer, remove drain bolt B also.
_
4. Clean the engine oil strainer with
solvent, and then check it for
damage and replace it if neces-
sary.
5. Check the O-ring for damage and
replace it if necessary.
PERIODIC MAINTENANCE AND ADJUSTMENT
6. Install the engine oil strainer,
compression spring, O-ring and
engine oil drain bolt, and then
tighten the drain bolt to the speci-
fied torque.
TIP
_
Make sure that the O-ring is properly
seated.
_
Tightening torque:
Engine oil drain bolt A:
22 Nm (2.2 m·kgf, 16 ft·lbf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf, 15 ft·lbf)
7. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
Engine oil brand:
YAMALUBE
Engine oil type:
See page 9-1.
Oil quantity:
0.8 L (0.85 US qt, 0.70 Imp.qt)
7-12
TIP
_
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
_
NOTICE
_
●
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
●
Make sure that no foreign mate-
rial enters the crankcase.
_
8. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the en-
gine off and check for the cause.
9. Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA11620
7