Replacing The Fuse - Yamaha AL125FC 2012 Owner's Manual

To charge the battery
Have a Yamaha dealer charge the bat-
tery as soon as possible if it seems to
have discharged. Keep in mind that the
battery tends to discharge more quickly
if the vehicle is equipped with optional
electrical accessories.
NOTICE
_
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional battery
charger will damage the battery.
_
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure the key is
turned to "OFF", then discon-
nect the negative lead before
disconnecting the
lead.
[ECA16302]
PERIODIC MAINTENANCE AND ADJUSTMENT
2. If the battery will be stored for
more than two months, check it at
least once a month and fully
charge it if necessary.
3. Fully charge the battery before in-
stallation. NOTICE: When in-
stalling the battery, be sure the
key is turned to "OFF", then
ECA16521
connect the positive lead be-
fore connecting the negative
lead.
[ECA16840]
4. After installation, make sure that
the battery leads are properly
connected to the battery termi-
nals.
NOTICE
_
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
_
NOTICE
_
Do not ride the vehicle with the bat-
tery disconnected or with a low-
positive
charged battery. This will cause
hard engine starting, decreased
headlight life, and the flasher lights
may not operate properly.
_

Replacing the fuse

ZAUU0648
1. Fuse cover
2. Screw
The fuse holder is located behind panel
ECA16530
A. (See page 7-8.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
2. Remove the starter relay cover by
ECAU0050
3. Pull the starter relay out.
7-28
2
all electrical circuits.
removing the screw.
EAUU0851
1
7