Replacing An Auxiliary Light Bulb; Replacing A Front Turn Signal Light Bulb; Replacing A Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha Ego Avantiz Owner's Manual

Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb
burns out, replace it as follows.
1. Remove cowling A. (See page
7-8.)
2. Remove the auxiliary light socket
(together with the bulb) by pulling
it out.
1
1. Auxiliary light bulb socket
3. Remove the burnt-out bulb by
pulling it out.
4. Insert a new bulb into the socket.
5. Install the auxiliary light socket (to-
gether with the bulb) by pushing it
in.
6. Install the cowling.
Periodic maintenance and adjustment
EAUW0345
Replacing a front turn signal
light bulb
1. Remove cowling A. (See page
7-8.)
2. Remove the turn signal light bulb
socket (together with the bulb) by
turning it counterclockwise.
1
1. Turn signal light bulb socket
3. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
4. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
5. Install the socket (together with
the bulb) by turning it clockwise.
6. Install the cowling.
7-28
EAU47742
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
If a tail/brake light bulb or a rear turn
signal light bulb burns out, replace it as
follows.
Tail/brake light bulb
1. Open the seat. (See page 4-9.)
2. Remove panel C. (See page 7-8)
3. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise and pulling the tail-
light bulb socket up at an angle.
1. Tail/brake light bulb socket
4. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
EAUN0490
7
1