CMOS Clear
JBT1 is used to clear the CMOS. Instead of pins, this "jumper" consists of contact
pads to prevent accidental clearing of the CMOS. To clear the CMOS, use a metal
object such as a small screwdriver to touch both pads at the same time to short
the connection.
Note: Be sure to completely shut down the system, and then short JBT1
to clear the CMOS.
Watch Dog Enable/Disable
The Watch Dog (JWD1) is a system monitor
that will reboot the system when a software
application hangs. Close pins 1-2 to reset
the system if an application hangs. Close
pins 2-3 to generate a non-maskable inter-
rupt signal for the application that hangs.
See the table on the right for jumper set-
tings. The Watch Dog must also be enabled
in the BIOS.
InfiniBand
VGA
COM1
JIB1
JPME2
B
LEDPWR
JWD1
LE8
InfiniBand Chip
LEDBMC
BIOS
PCH
JBT1
X10DRT-L
Rev. 1.00
CPU1
IPMI CODE
CLOSE 1st
CPU2
OPEN 1st
FAN3
FAN1
LAN2 LAN1
USB0/1(2.0)
IPMI_LAN
LAN
CTRL
I-SGPIO2
BT1
BMC
A
JPI2C1
2-33
Chapter 2: Installation
Watch Dog
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Reset (default)
Pins 2-3
NMI
Open
Disabled
A. Clear CMOS
B. Watch Dog Enable