LUCCI Air PUMA Installation Instructions

Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.

Warranty

•
This exhaust fan is covered by a 2 year warranty. The warranty is from date of purchase, not the date of installation.
•
Please retain proof of purchase for any warranty enquires.
•
Warranty will be void if there is any damage due to improper usage or modification to the fan.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.

Installation requirements

•
A licensed electrician is required to install this unit to the mains supply.
•
All wiring and installation of the exhaust fan must adhere to the local council regulation and latest local and national
wiring rules, eg. AS/NZS 3000 electrical installations. If unsure, contact a licensed electrician.
•
This product is suitable for indoor use only. Its faceplate is rated IP24 after being installed into the ceiling.
•
This product must be installed at least 2.1 m above the floor level.
•
It is recommended to install the product in an area smaller than 7m
•
Before cutting a hole in the ceiling, check that there are no ceiling joists, etc. or electrical wiring above the desired
mounting location.
•
The mounting point must be support at least 2 times of the weight of the product.
•
Ensure all the clearance values to the structural building element are maintained according to the clearance diagram
in Figure A7.
•
Do not install the exhaust fan in canopies over stoves etc., as excessive heat will damage the product.
•
This product is designed for installation in the flat ceiling only. Do not mount it on a sloping ceiling or a vertical wall.
•
Any duct (not included) attached to the product must be installed horizontally in the ceiling and with the same height
or lower than the exhaust fan.
•
Ensure the duct (not included) is not bent otherwise the performance will be reduced.
•
Where applicable, precautions must be taken to avoid the back-flow of gases into the room from the open flue of
gas or other fuel-burning appliances.
•
Do not allow any thermal insulation to cover any part of the rear of the appliance.
•
Ensure the thermal insulation does not obstruct the airflow.
•
There must be an adequate source of external air to ensure the rated performance.

Installation directions

1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material.
NOTE: Take care not to pull any electrical wires during unpacking as this may damage the connection.
2. Check whether the product has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
3. Identify a location to install the exhaust fan. Make sure all clearance can be kept according to the clearance
diagram. (Fig.A7)
4. Cut an installation hole into the ceiling using the cut-out template provided. (Fig.A1)
5. Attach the duct (Not included) to the exhaust outlet if needed.
6. Connect the supply wires to the terminal block provided according to the circuit diagram (Fig.A8).
7. Install the main body of the appliance to the ceiling by the 3 screws provided. (Fig.A2)
1 | P a g e
PUMA EXHAUST FAN
SKU# 209020, 209021
Rated Voltage 220-240V~ 50Hz
2
.
v 1 . 0 ( 0 9 / 2 0 1 9 )