Technical Data; Device Data - Siemens 7XV5654-0BA00 Manual

Technical Data

5.1 Device Data

5.1

Device Data

Supply Voltage
Auxiliary voltage – direct voltage
Permissible ripple of the DC input voltage
Power consumption
Maximum inrush current at ≤ 110 V
Maximum inrush current at 220 V to 300 V
Efficiency level
Auxiliary voltage – alternating voltage
Permissible higher harmonics
Maximum inrush current at ≤ 115 V
Maximum inrush current at 230 V
Power consumption
Power-failure backup
Output-voltage status display
Fault-Signaling Connection (Relay)
Relay
Maximum contact voltage with a resistive load
Maximum switching current
Maximum switching power
Permissible current for contacts
Test voltage
Electronic Load Disconnecting Relay (K2)
Binary outputs (OPTOMOS)
Permissible current for contacts
Minimum switching current
Maximum switching power
Test voltage
Binary Input BI 2
Binary input
Switch threshold value
Input current
Pickup time
46 Accessories, Sync Transceiver, Optical/Electrical Converter for Time Synchronization, Manual
DC 24 V to 250 V (± 20 %)
15 %
3 W
< 15 A
≤ 22 A
After 250 μs: < 5 A
> 50 % at rated load
AC 60 V to 230 V (± 20 %) at 45 Hz to 65 Hz
2 kHz
< 15 A
≤ 22 A
After 250 μs: < 5 A
7 VA
Min. 50 ms at rated load
1 green LED to display the operating state
Standard relay, 1 break contact, isolated; 2-pole
terminal
AC 240 V
5 A
AC 2000 VA
5 A
V = 3.51 kV
RMS
DC 24 VDC to 250 V; +15 %/-20 %
100 mA
1 mA
Maximum 250 mW average internal power dissipa-
tion; dependent on the switching frequency
V = 3.51 kV
RMS
DC 24 V to 250 V; +15 %/-20 %
Can be switched using the jumper X100:
– Approx. 17 V with jumper position 1‑2
– Approx. 70 V with jumper position 2‑3
< 5 mA
Approx. 5 ms
C53000-G9050-C168-1, Edition 09.2019