GENERAL INFORMATION
PARTS IDENTIFICATION
Table 3 an<l Figure 4 Identifies the parts that make-up the SX-55 Extractor Handp l ece. Refer
to Table 3 and Figure 4 for locat10n and Identificat i on of each part.
TABLE 3. SX-55 EXTRACTOR HANDPIECE PARTS IDENTIFICATION
HEATER ASSEMBLY - supplies heal to
•
•
HEAT OISSIPATOR-reduces
•
HEATER ASSEMBLY MOUNTING SCREWS-mount i n g screws for att a ching Heater Assembly
to Handp1ece.
•
HEAT D I SSIPATOR MOUNTING SCREWS-mounting screws for attaching Heat D i ssipator
10 Handplece.
•
HEAT O I SSIPATOR WASHER-spacer separating the Heat D 1 ssipator
•
LOWER HANDPIECE SHELL- I owa· sect i on oi SX-55 Ex1ractor Handplece.
•
UPPER HANOPIECE SHELL-upper sect i on o f SX-S5 Extractor Handp i ece.
P
•
RAM
-aflgnmenr gu i des for Glass Chamber.
CORD ANO SWITCH ASSEMBLY -supp li es AC power to
•
Power Source.
•
SPACER-provides positioning oi tha Cord and Switch Assemoly within Upper Handp,ece
Shell.
C-CUPS-reta i ning cl
•
SWITCH ASSEMBLY MOUNT I NG SCREWS-
•
Assembly to Upper Handpiece Shell.
•
HANDPIECE MOUNTING SCREWS-mounting screws for attaching Upper and Lower Hand
piece Shells together.
END CAP ASSEMBLY -prov i des
•
Handp i ece.
•
GLASS CHAMBER-coUectlcn chamber for extracted so l d e r .
•
·s·
BAFFLE-breaks up extracted so l der i n Glass Chamber.
SX -55 EXTRACTOR FILTER-prevenls ex1rac,ed so l der and/or contaminates from entering
•
Power Source Motor/Pump.
the
heat
transfer from the Heater Assembly to the Handpiece.
i
ps holding U�per and
a
,acuum line lrom the Power Source to SX - 55 Extractor
8
Extract o r Tip.
S X - 5 5 Extractor Handp i ece from
the
Lower
Handpiece Shells together.
mounting
screws for attaching
from
the Handplece.
Cord and
Sw i tch
-
�
�
-