Table of Contents
Advertisement
COM port-to-PC cable – DB9 connector (14 feet – 4.3 m)
Ferrite choke
FrameSaver SLV 9820 Quick Reference (Document No. 9820-A2-GL10)
Additional cables may be ordered. See Cables You Can Order on page 3 when
ordering cables.
Be sure to register your warranty at www.paradyne.com/warranty.
Before You Begin
If you ordered a wall mounting kit (Feature No. 9001-F1-891) for your FrameSaver unit,
install the wall mounting before you start installing the unit. Follow the same guidelines
below when installing the wall mounting. Contact your sales representative to order this
feature.
Before starting the installation, make sure you have:
A dedicated, grounded power outlet that is protected by a circuit breaker within
6 feet of the FrameSaver unit.
A clean, well-lit, and ventilated site that is free from environmental extremes.
One to two feet of clearance for cable connections.
A physical connection to the frame relay network via an NTU, with either an
EIA-530, V.35 or an X.21 user interface. This connection is made using the
appropriate cable attached to the Network port of the FrameSaver unit.
This cable is not supplied with your FrameSaver unit, and you will need to order
the appropriate cable kit for your application, V.35, X.21, or EIA-530 (see page 3
for the Feature No. you need to order).
An async (asynchronous) terminal or PC (personal computer) to set up the
access unit.
Node IP Addresses and Subnet Masks (see your network administrator).
See the User's Guide for additional information on:
Troubleshooting
Technical Specifications
Cables, Connectors, and Pin Assignments
2
Advertisement
Table of Contents
