Table of Contents
Advertisement
Connecting to the Network
Now that the FrameSaver unit is set up, the unit can be connected to the network.
1. Insert the DB25 connector of the network cable into the network data port.
2. Insert the other end of the cable into the NTU (EIA-530, V.35 or X.21).
NOTE:
After connecting the network cable, wait about a minute to allow
Auto-Configuration a chance to discover DLCIs.
3. Check that the Network (NET OK) LED is on. If yes, the network interface is set up
correctly and it is operational. If not, make sure both ends of the network cable are
properly seated and secured.
4. Verify that the network physical options are configured correctly.
Main Menu
5. Check Health and Status messages in the left column of the System and Test
Status screen to see the LMI status and verify that LMI is up.
Main Menu
If LMI Down, Net1-FR1 appears for more than three minutes, or any other
network-related status message appears, refer to the status information in
Operation and Maintenance of the User's Guide for possible reasons.
NTU
Configuration
Network
Status
System and Test Status
98-16199
Physical
11
Advertisement
Table of Contents
