EnerSys OLDHAM CAP LAMP M656201 Instruction Manual

EnerSys OLDHAM CAP LAMP M656201 Instruction Manual

Single lamp charger

Advertisement

C
A
P
L
A
M
C
A
P
L
A
M
S
I
N
G
L
E
L
S
I
N
G
L
E
L
The Powerful Choice
This manual, including the warnings and cautions inside, must be read and followed carefully by all
persons who use or maintain this product, including those who have any responsibility involving its
selection, application, service, or repair. This cap lamp system will perform as designed only if used and
maintained according to the instructions, otherwise it could fail to perform as designed and persons who
rely on this product could sustain serious personal injury or death.
P
S
Y
S
T
E
P
S
Y
S
T
E
A
M
P
C
H
A
A
M
P
C
H
A
INSTRUCTION
MANUAL
M
M
R
G
E
R
R
G
E
R
WARNING

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OLDHAM CAP LAMP M656201 and is the answer not in the manual?

Questions and answers

Summary of Contents for EnerSys OLDHAM CAP LAMP M656201

  • Page 1 The Powerful Choice INSTRUCTION MANUAL WARNING This manual, including the warnings and cautions inside, must be read and followed carefully by all persons who use or maintain this product, including those who have any responsibility involving its selection, application, service, or repair. This cap lamp system will perform as designed only if used and maintained according to the instructions, otherwise it could fail to perform as designed and persons who rely on this product could sustain serious personal injury or death.
  • Page 2: Cautions And Warnings

    Technical Data . M656201 ART NO Charging Method Automatic constant current / constant potential 115 / 230 V AC, Initial Charging Current 2.5 A max. Charging Voltage 5.3 VDC switching to 5.1 VDC (float mode 4.6 VDC) SINGLE PHASE Charging Time Approximately 8 hrs.
  • Page 3: Operation

    CAUTION After connection of the cap lamp, the red LED will Operating the charger from illuminate after a short time, 230 VAC while switched for the circuitry will wait 5 115 VAC will permanently seconds then start damage charger constant current charge transformer and the charger...
  • Page 4 MAINTENANCE fuse holder located on the under AND ORDERING side of the charger, INFORMATION adjacent to the voltage selector switch. replace a blown fuse, THERE ARE NO USER unscrew the fuse holder REPLACEABLE PARTS cover anti-clockwise. OTHER THAN THE FUSE. Remove the blown fuse, CHARGER place the new fuse in...
  • Page 5: Troubleshooting Guide

    TROUBLESHOOTING GUIDE FAULT FINDING CHARGER NOT OPERATING Is yellow illuminated? Check mains input fuse and confirm voltage is present and corresponds to voltage selected on changeover switch Is output voltage Replace charger present? Has fuse Replace blown? fuse Check cap lamp? Check mains supply Replace headpiece and...

Table of Contents