Table of Contents
Advertisement
v Error: When this amber LED is lit, it indicates that an error has been
detected somewhere on the management module. When this LED is lit, the
system error LED (critical, major, or minor) on each of the BladeCenter T
system-status panels is also lit.
Management-module IP reset button: Do not press this button unless you
intend to erase your configured IP addresses for the management module and
lose connection with the remote management station, the switch modules, and
the blade servers. If you press this button, you will have to reconfigure the
management module settings (see the information beginning with Chapter 4,
"Configuring the management module," on page 27 for instructions).
Press this recessed button to reset the IP configuration of the management
module network interfaces (Ethernet 1, Ethernet 2, gateway address, and so on)
to the factory defaults and then restart the management module.
Use a straightened paper clip to press the button.
KVM (keyboard, video, mouse) module indicators and
input/output connectors
The KVM module is a hot-swap module that is installed on the rear of the
BladeCenter T unit and is held in place by captive thumbscrews. This module
contains two PS/2 connectors for the keyboard and mouse, a system-status
panel, and an HD-15 video connector.
Thumbscrew
Keyboard
Power LED
22
BladeCenter T Management Module: Installation Guide
Mouse
CRT
Major (MJR) alarm LED
Minor (MNR) alarm LED
MNR
MJR
Video
Critical (CRT) alarm LED
Location LED
Advertisement
Table of Contents
