Table of Contents
Advertisement
Complete the following steps to remove a management module.
Note:
v These instructions assume that the BladeCenter T unit is connected to
power.
v If you are removing the only management module in the BladeCenter
T unit, you might prefer to stop all management-module local and
remote sessions before proceeding, to avoid unexpected termination of
sessions.
v If you are removing the only management module in the BladeCenter
T unit, be aware that as soon as you remove the module from the
BladeCenter T unit, the blowers will increase to full speed.
v If you are replacing the only management module in the BladeCenter
T unit and the management module is functional, you might want to
save the configuration file to another medium before you proceed
(under the MM Control section in the navigation pane, click
Configuration File and follow the instructions under Backup MM
Configuration). You will be able to restore the saved configuration file
to the replacement management module (under the MM Control
section in the navigation pane, click Configuration File and follow
the instructions under Restore MM Configuration). See the IBM
Eserver BladeCenter T Management Module User's Guide for more
information.
v If you have just installed a second management module in the
BladeCenter T unit, do not remove the first (primary) management
module for approximately 2 minutes; the second (secondary)
management module needs the time to receive initial configuration
and status information.
1. Read the safety information beginning on page v and "Installation
guidelines" on page 7 through "Handling static-sensitive devices" on page
8.
2. Remove the bezel from the front of the BladeCenter T unit (see step 3 on
page 13 for instructions).
3. Connect an ESD wrist strap to the ESD connector at the front of the
BladeCenter T unit (see the illustration on page 9 for the location of the
ESD connector).
4. Press the blue release button at the front of the management module.
5. Pull the release latch all the way toward the left side of the management
module until it stops, as shown in the illustration. The management
module moves slightly out of the bay.
16
BladeCenter T Management Module: Installation Guide
Advertisement
Table of Contents
