Assembly Instructions - RAIS Q-Tee Series User Manual

English

Assembly Instructions

• Remove the front cover (1) and door (2) from the combustion chamber (6). Note that
the door lock is to be turned clockwise before the door can be removed.
• Remove the vertical cover (4), the horizontal stop for ashes (3) and remove 2x M6 hex
screws (5) between the combustion chamber and the bracket (7). The nuts (11) for
the bracket (12) must only be loosened and the bracket can be removed.
• The burning chamber is removed from the mantle.
• The reflector plate (9) can be removed if the installation is with a rear brick wall,
otherwise it is recommended in other installations.
• Place the mantle (8) in the wall opening - adjustment is done using the 4 set screws.
Be aware that the mantle must be leveled and adjusted vertically, and can be fastened
to the side wall using angle brackets or frame screws.
• The remainder of the stove is assembled in reverse order.
• Check that the cover is parallel to the wall and flush with the steel door frame (steel
door), or with the door glass list (glass doors) in the closed position - if necessary,
adjust the stove forward or backward.
If desired, the cover can be provided in special outer dimensions.
Contact your RAIS dealer. This can be ordered with the stove.
48
In case of top outlet, the knock-out
plate of the mantle is removed.
Door lock.
Loosen the screw and turn the
lock clock-wise for unlocking.
2
1
RAIS - Manual for RAIS Q-Tee
5
4
3
7
12
6
9
8
10
11
12