Table of Contents
Related Manuals for RAIS Q-BE INSERT
Summary of Contents for RAIS Q-BE INSERT
- Page 1 B R U G E R M A N U A L B E D I E N U N G S A N L E I T U N G User MANUAL M A N U E L D ’ U T I L I S AT E U R BRUKSANVISNING B R U K S A N V I S N I N G KÄYTTÖOPAS...
- Page 2 English RAIS/ - User Manual Q-BE INSERT HEAT YOUR PLACE IN AN ECO-FRIENDLY WAY! 3 Eco-friendly advices for rational heating - common sense for both the environment preservation and saving your money 1. Efficient lighting. Use small pieces of wood (fir tree) and a suitable fire lighter - such as waxed wood wool/sawdust.
-
Page 3: Table Of Contents
SPECIFICATIONS ........................6 MEASUREMENTS ........................7 CONVECTION ........................8 SELECTION OF INSTALLATION MATERIALS ................8 CHIMNEY ..........................9 INSTALLATION ........................10 Q-BE INSERT - INSTALLATION OF THE INSERT ..............11 CORNER SETTING .......................12 FUEL ...........................14 DRYING AND STORAGE ......................15 AUTOMATIC REGULATION OF COMBUSTION AIR (CLEVERAIR™) ........15 VENTILATION ........................15 FIRST USAGE ........................16... -
Page 4: Introduction
English RAIS/ - User Manual Q-BE INSERT Introduction attika Congratulations on your new RAIS / stove. attika RAIS / wood stove is more than just a heat source, it also shows that you care about design and quality in your home. -
Page 5: Warranty
We will ensure professional repair of the damage. Warranty claims on additionally delivered or repaired parts are subject to national/EU laws/regulations related to the warranty period renewals. Please, contact RAIS A/S for the applicable warranty provisions. -
Page 6: Specifications
English RAIS/ - User Manual Q-BE INSERT Specifications DTI Ref.: 300-ELAB-2153-EN / 300-ELAB-2153-NS Q-BE INSERT Nominal output (kW): Min./Max. output (kW): 4 - 8 Heating area (m 60 - 120 Stove's width/depth/height (mm): 424/422/970 Combustion chamber's width/depth/height (mm): 239/239/505 Recommended amount of wood when fuelling (kg): (distributed on 3 logs of wood of approx. -
Page 7: Measurements
English RAIS/ - User Manual Q-BE INSERT Measurements Set fra bagside Air inlet same center as outlet Set fra bagside... -
Page 8: Convection
Discolouration of the stove walls, doors and convection outlets may occur. Such discolouration is caused by convected hot air. RAIS assumes no responsibility for any installation works or consequential damages. Selection of installation materials For non-combustible materials, the selected panels/bricks should have minimal thermal resis- tance value greater than 0,03 m x K/W. -
Page 9: Chimney
The chimney height must be sufficient to ensure the correct draught of 14 to 18 Pa. If the chim- ney draught is lower than recommended, there may be problems problems of smoke leaking into the room when the stove is lit. RAIS recommends to adjust the chimney height with the flue pipe collar. The chimney should be at... -
Page 10: Installation
European standards are observed. Local authorities and a chimney specialist should be contacted prior to installation. The stove may only be installed by a qualified/competent RAIS dealer/installer, otherwise, the warranty will be voided. It is prohibited to carry out unauthorised alterations to the stove. -
Page 11: Q-Be Insert - Installation Of The Insert
- User Manual Q-BE INSERT attika When you choose where to set up your RAIS/ wood burning stove, you should con- sider the heat distribution to the other rooms. This will enable you to get the best use out of your stove. -
Page 12: Corner Setting
English RAIS/ - User Manual Q-BE INSERT Corner setting Uninsulated flue Inner distance (A) Outer distance (B) to non-combustible material (min) to combustible material (min) 50 mm 350 mm 100 mm 0 mm For example: With a distance to non-combustible wall 50mm (A), the distance to flammable wall/door frame should be 350mm (B). -
Page 13: Fuel
English RAIS/ - User Manual Q-BE INSERT In order to guide the hot air out of the convection vents, install a beveled non-combustible plate (such as Fermacell) just above the Convection holes should be vents. located just below the beveled plate. -
Page 14: Drying And Storage
English RAIS/ - User Manual Q-BE INSERT We do not recommend stoking with painted, laminated or impregnated wood, wood with a synthetic surface, painted refuse wood, chipboard, plywood, domestic waste, paper briquettes and pit coal, as this will produce malodorous smoke, which could be poisonous. -
Page 15: Automatic Regulation Of Combustion Air (Cleverair™)
English RAIS/ - User Manual Q-BE INSERT Automatic regulation of combustion air (CleverAIR™) This stove is equipped with an independent and self-regulating air damper. Hence there is no damper handle. You need only to add the dry wood and light it. -
Page 16: First Usage
English RAIS/ - User Manual Q-BE INSERT First usage A careful start pays off. Start with a small fire, so that the wood burning stove can get accus- tomed to the high temperature. This gives the best start and any damage is avoided. - Page 17 English RAIS/ - User Manual Q-BE INSERT...
-
Page 18: Control
When refuelling, open the door carefully in order to avoid smoke escaping. Never add wood while there is fire with flames in the stove. RAIS recommends to refuel with 1-2 pieces wood - approx. 1- 1 ½ kg - within 46 minutes (intermittent operation) NOTE! Keep an eye on the stove when lighting. - Page 19 English RAIS/ - User Manual Q-BE INSERT Hvis brændet kun ulmer eller ryger, og der tilføres for lidt luft, udvikles der Hvis brændet kun ulmer eller ryger, og der tilføres for lidt luft, udvikles der Hvis brændet kun ulmer eller ryger, og der tilføres for lidt luft, udvikles der uforbrændte røggasser.
-
Page 20: Cleaning And Care
• Rub with a piece of paper and the glass will become clean. • Alternatively, you can use glass polish, which you can obtain from your RAIS dealer. Clean the exterior with a soft dry cloth or a soft brush. Prior a new heating season, it should be checked that the chimney and smoke gas connector are not blocked. -
Page 21: Cleaning The Flue
English RAIS/ - User Manual Q-BE INSERT Cleaning of flue ways In order to access the smoke flue, remove the upper plate – baffle plate made of vermiculite and the smoke barrier (steel plate). Carefully remove the baffle plate by lifting Then, lower the front corner and care- off the plate and pulling it forward. -
Page 22: Malfunctions
English RAIS/ - User Manual Q-BE INSERT Remove dirt and dust, and mount the parts in reverse order. NOTE! Be careful when replacing the smoke converter plate and the smoke barrier. Malfunctions Smoke spillage around door May be caused by too weak draft in the chimney <12Pa •... - Page 23 With cold chimney or severe weather conditions, the poor draught can be compensated by sup- plying the stove with more air than usual. If the malfunction persists, we recommend that you contact your RAIS dealer or the chimney sweep. WARNING!
-
Page 24: Accessories Q-Be
Spare parts Q-BE INSERT 707480890 The use of spare parts other than those recommended by RAIS voids the warranty. All replaceable parts can be bought as spare parts from your RAIS dealer. For reference, see spare parts drawing (next page). - Page 25 English RAIS/ - User Manual Q-BE INSERT...
-
Page 26: Test Certificate (Denmark)
English RAIS/ - User Manual Q-BE INSERT Declaration of performance... -
Page 27: Ce Label
Foyer à durèe de combustion limitèe, homologué pour cheminée à connexions multiples. Utiliser seulement les combustibles recommandés. Hergestellt für /Produced for: ATTIKA FEUER AG, Brunnmatt 16, CH-6330 Cham / RAIS A/S, Industrivej 20, DK-9900 Frederikshavn 15a B-VG Reference / DTI test report:... - Page 28 ATTIKA FEUER AG Brunnmatt 16 CH-6330 Cham Switzerland www.attika.ch RAIS A/S Industrivej 20 DK-9900 Frederikshavn Denmark www.rais.dk...
Need help?
Do you have a question about the Q-BE INSERT and is the answer not in the manual?
Questions and answers