Selection Of System Modes; Viewing Temperature - Siemens POLYCOOL RWR470.10 Basic Documentation

Siemens Building Technologies
HVAC Products

Selection of System Modes

Display
.
The selection sequence of system modes varies with the <Plus> or <Minus> button you
selected based on the current system mode (SF01). The corresponding icon(s) for
system mode will blink once selected.
If the current system is heating&cooling(when SF01=1) , the full sequence of selecting
the system modes will be as follows.
Activity
Press <Plus>

Viewing temperature

Display
.
Display
.
.
Code
RT
Inlet water temperature of indoor side
ST
Outlet water temperature of indoor side
OT
Atmospheric temperature of outdoor
HT
Hot water temperature
STo
Outlet water temperature of outdoor side
ET
Inlet water temperature of outdoor side or evaporating temperature
SIEMENS Controller
Procedures
In stop mode,press the <Plus> button for 2
seconds, and release it to activate the
+
selection of system mode. The currently
system mode will start flashing.
-
Press <Plus> or <Minus> to select the desired
system mode, and then press<Enter > to
confirm.
Sequence
 
Procedures
In normal working mode, press <plus> or
<minus>to look into the temperature.
+
-
Procedures
In stop mode, press the <Enter> button for 2
seconds and release it to enter the Menu
+
mode.
- By default, the Query
waiting for further instructions.
Press the <Enter> button to enter the query
+
mode.
press <plus> or <minus>to look into the
-
temperature.
Describe
icon is blinking,
10/28
HEAT PUMP controller
27.11.2006