Electronics Line Penta Installation Manual page 27

Primary
Telephone Number
Quick Arming
Ready
Remote
Programmer
Restore
RP
RP Access Code
Silent Alarm
Stay Arming
Stop
Communications
Tamper Zone
Tone
Unbypass
User Code
Voice Message
Walk Test
Zone
Zone Chime
The first telephone number dialed when an event occurs. If
communication can not be established with the Primary telephone the the
Backup telephone number is dialed.
Arming the system without the need for a valid user code.
The state in which all zones are closed and the system is ready to be
armed.
The software developed by Electronics Line used for programming the
system using a PC from a remote location or on-site.
The restoral of a trouble condition to its normal state. For example, if AC
power is reconnected, an AC Loss Restore event code is sent to the
central station.
Abbreviation of Remote Programmer
The code that grants access to the remote programmer. The RP Access
Code prevents the system being sabotaged using unauthorized remote
programming.
An alarm that does not activate the bell/siren when generated.
Arming the perimeter of the system while allowing free movement in the
interior zones.
An operation that clears all communication buffers and stops all
communications immediately.
The fifth zone which can be connected to a tamper switch protecting the
control panel by generating an alarm when the metal housing is opened.
Alternately, the tamper zone can be defined for use with an On/Off
keyswitch.
See Beep
The restoral of a bypassed zone to its original state.
A code that grants access to certain operational capabilities such as
arming and disarming the system.
A short message played by the 3601 module to announce an alarm over
the telephone line.
A mode that enables detection devices to be tested without generating an
alarm.
The physical and logical connection of detection devices to the control
panel.
The tone sounded by a keypad on opening a perimeter zone when the
system is disarmed.
-27-
Q
R
S
T
U
V
W
Z