Table of Contents
Advertisement
TRANSPORTATION
When lifting the machine, carry out the operation on flat ground
as follows.
1. Start the engine, then swing the turret so that the work
e q u i p m e n t i s a b o v e t h e s p r o c k e t s ( 1 ) w i t h t h e
undercarriage and the turret parallel to each other.
2. Lift the blade completely.
3. Extend the bucket cylinder, the arm cylinder and the boom
cylinder completely.
4. If the boom is swing to the left or to the right, operate the
boom swing pedal to position the boom parallel to the
undercarriage, then lock the pedal safety device.
5. Place the safety locking lever (1) in the LOCK position (L).
q Canopy specification
q Cab specification
6. Stop the engine, make sure there is nothing inside the
operator's cab, and then get off the machine.
If the machine is fitted with cab, close the door and the
front windscreen.
7. Install shackles in the lifting holes on both ends of the
blade (2 points), then pass the wire cables through them.
3-102
WEAM014500
FUNCTIONING
RKA32810
Advertisement
Table of Contents
