Reer Mosaic Series Manual page 20

Mosaic fieldbus modules
Once the module is connected it is recognised and you can configure the parameters by
selecting the different cards shown in figures 9 to 11 (
key to send the configuration data to the module.
Figure 10 - I/O selection
Figure 12 - Baud rate
After setting the parameters, click on the "MONITOR" key.
8540801 • 01/02/2017 • Rev.15
figure 7); press the
Figure 11 - Address
input status,
fieldbus input status,
127 AUTO
probe status,
output status
input status,
fieldbus input status,
63 AUTO
probe status,
output status
input status,
fieldbus input status,
126 N/A
probe status,
output status
input status,
fieldbus input status,
0 N/A
probe status,
output status
input status,
fieldbus input status,
0.0.0.0 AUTO
probe status,
output status
input status,
fieldbus input status,
0.0.0.0 N/A
probe status,
output status
Table 5 - Default values
20