Panasonic MICRO-IMAGECHECKER A200 Series Hardware Manual page 57

About Camera Modes
5.2 Imaging Time for the Camera Modes (for memory image display) and Resolution
5.2 Imaging Time for the Camera Modes (for memory
image display) and Resolution
Frame
Double−Speed p Imaging time = (shutter time) + 16.7ms
Random Ra do
Resolution = 512 × 480 pixels
Supports moving and still objects, continuous
light.
Camera = ANM831
To switch between frame and field modes, you must change the settings on the controller
menu and change the DIP switch settings on the back of the camera. See note 1)
Set the camera shutter speed from the controller menu.
Normal Imaging time = 33.3 to 50ms
I te al S Internal Sync c
Resolution = 512 × 480 pixels
Supports still objects and continuous light.
Supports moving objects with strobe light that
uses the FLASH signal. See note 2)
Camera = ANM832 See note 3)
To switch between frame mode and field mode, change the settings on the controller menu.
Set the camera shutter speed using the controller menu.
1) See the information about DIP switches on page 1−6.
2) When using a strobe light, set to normal frame mode, and be certain to switch the monitor display to
"Memory Display". If the monitor display is set to "Through Display", the strobe will flash continuously.
3) The internal sync is an NTSC signal input.
5 − 4
Start Trigger
Shutter−time
16.7ms
t= (Shutter−time) + (1/60s)
Start Trigger
Delay−time
=0 to16.7ms
33.3ms
t= (1/30s) to (1/20s)
A200/A100 Hardware
Field
Imaging time = (shutter time) + 8.3ms
Start Trigger
Shutter−time
8.3ms
t= (Shutter−time) + (1/120s)
Resolution = 512 × 240 pixels
Supports moving and still objects, continuous
light
Imaging time = 16.7 to 33.3ms
Start Trigger
Delay−time
16.7ms
=0 to 16.7ms
t= (1/60s) to (1/30s)
Resolution = 512 × 240 pixels
Supports moving and still objects, continuous
light.