Serial (Rs−232C) Ports - Panasonic MICRO-IMAGECHECKER A200 Series Hardware Manual

A200/A100 Hardware
4.1 Serial (RS−232C) Ports
The controller contains two independent serial ports.
The COM port is an 8−pin round connector. It is used for general RS−232C
communication.
The TOOL port is a square connector. It is used only for connection to VBT Ver. 2.
An application stored in the controller determines the commands and parameters such
as baud rate and parity used for communication. For details see each individual user
manual.
COM port
TOOL port
Using the Ports Correctly
− The A Series can be set to perform flow control of RS−232C communications. (For
details, see the individual manuals.)
− There may be cases where normal communications are not possible with the
high−speed transmission speed setting owing to the type of the equipment used for
communications. Ensure that the conditions of actual usage are verified prior to
operations.
Serial (RS−232C) Ports
4.1 Serial (RS−232C) Ports
4 − 3