Avalue Technology EAX-H81P User Manual page 64

EAX-H81P User's Manual
Stop Bits
Flow Control
VT-UTF8 Combo Key
Support
Recorder Mode
Resolution 100×31
Legacy OS Redirection
Resolution
Putty KeyPad
Redirection After BIOS
POST
64 EAX-H81P User's Manual
1[Default]
2
None[Default]
Hardware RTS/CTS
Disabled
Enabled[Default]
Disabled[Default]
Enabled
Disabled[Default]
Enabled
80X24[Default]
80X25
VT100[Default]
LINUX
XTERMR6
SCO
ESCN
VT400
Always Enable[Default]
BootLoader
Stop bits indicate the end of a serial data
packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit.
Communication with slow devices may
require more than 1 stop bit.
Flow control can prevent data loss from
buffer overflow. When sending data, if the
receiving buffers are full, a 'stop' signal can
be sent to stop the data flow. Once the
buffers are empty, a 'start' signal can be sent
to re-start the flow. Hardware flow control
uses two wires to send start/stop signals.
Enable VT-UTF8 Combination Key Support
for ANSI/VT100 terminals.
On this mode enabled only text will be sent.
This is to capture Terminal data.
Enables or disables extended terminal
resolution.
On Legacy OS, Number of Rows and
Columns supported redirection
Select FunctionKey and KeyPad on Putty.
The Settings specify if BootLoader is
selected than Legacy console redirection is
disabled before booting to Legacy OS.
Default value is Always Enable which means
Legaacy console Redirection is enabled for
Legacy OS.