Installer Setting -How To Enter Installer Setting Mode; Installer Setting - Installer Setting Code Table - LG PQWRCQ0FDB Owners & Installation Manual

Installation Instructions

Installer Setting -How to enter installer setting mode

CAUTION
!
Installer setting mode is to set the detail function of the remote controller.
If the installer setting mode is not set correctly, it can cause problems to the product, user injury or
property damage. This must be set by an certificated installer, and any installation or change that is
carried out by a non-certificated person should be responsible for the results. In this case, free service
cannot be provided.
1
When JET COOL button pressed, press RESET button
2
By using the TEMPERATURE SETTING button, set function code
and setting value. (Please refer the Installer Setting Code Table.)
3
Press the ON/OFF button toward the indoor unit 1 time.
°C/°F(5 s)
TIME(3 s)
4
Reset the remote controller to use the general operation mode.
Refer to the Installer Setting Code Table on the next page.
8 Wireless Remote Controller
Function Code
Setting Code

Installer Setting - Installer Setting Code Table

Installer Setting Code Table
No. Function Function Code
0
0 Mode Override
1
Ceiling Height
1
Selection
2 2 2
Group Control
2
2
Auxiliary heater
Mode Override
This Function is only for Non-Auto Changeover H/P model.
Ceiling Height Selection
Indoor unit connected to wired remote controller operate as wired remote controller setting.
Group Control
This function is only for group control. Please don't set this function in case of non-group control.
After setting Group Control of the product, turn off the power then turn it back on after 1 minute.
Auxiliary heater
This function is only applied to models with Auxiliary Heater function being activated.
Installation Instructions
Setting Value Remote Controller LCD
00
0 : Set to Master
01
1 : Set to Slave
11
1 : Standard
12
2 : Low
13
3 : High
14
4 : Super High
20
0 : Set to Master
21
1 : Set to Slave
22
2 : Check Master/Slave
23
3 : Set to Auxiliary heater
24
4 : Cancel Auxiliary heater
25
5 : Check Auxiliary heater Installation
Owner's & Installation Manual 9