Advertisement
Please follow the instructions below to mount the dedicated focus gear on the lens.
1.
Insert the plastic c-ring as shown and place it
over the lens rubber focus ring.
2.
Insert the gear of EEF60-F on the plastic c-ring
until it reaches the flange of the plastic c-ring.
3.
Mount the alignment ring onto the lens by
screwing it into the thread on the front of the
lens.
4.
To remove the EEF60-F gear, reverse the above
steps.
5.
The tightness between the EEF60-F gear and the
lens can be adjusted by removing or adding
rubber grips on either sides of the plastic c-ring,
spare rubber grips are included in the package.
1
Advertisement
Table of Contents
Related Manuals for Nauticam EEF60-F
Summary of Contents for Nauticam EEF60-F
- Page 1 Insert the plastic c-ring as shown and place it over the lens rubber focus ring. Insert the gear of EEF60-F on the plastic c-ring until it reaches the flange of the plastic c-ring. Mount the alignment ring onto the lens by screwing it into the thread on the front of the lens.
- Page 2 Please follow the instructions below to mount the dedicated Macro port on the housing. 1. Detach A from the port by turning it anti- clockwise while holding B firmly. 2. Install the camera body only into the housing. *Please refer to the housing manual for installing camera into the housing.
- Page 3 4. Make sure the two knobs are at its most outwards position before mounting/ un- mounting the lens. The knobs should be left at this position until it is made sure that the lens and gear is properly installed. 5. Remove the O-ring from A, inspect for any damage and lightly coat it with the provided lubricant.
Need help?
Do you have a question about the EEF60-F and is the answer not in the manual?
Questions and answers